McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams



7AM - 5PM CST 7 Days a Week


Subscribe to receive members-only deals in your email


ORDERS $149+

View Details



Shop for car parts & accessories, car detailing products, car engine oil and more.

Items 1-10 of 414

per page
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Grid List

Set Ascending Direction
  1. Johnsen's R134a Refrigerant 30 LB Cylinder 6330

    Johnsen's R134a Refrigerant 30 LB Cylinder 6330


    Keep you car’s air conditioner cool all summer long with this value-size 30lb cylinder of R134/R134a Refrigerant. The large size will save you time and money. Instead of purchasing several small cans of refrigerant, just one of these 30lb cylinders will allow for multiple recharges. This product is for use in retrofitted and/or factory installed R134a auto air conditioning units. Standard ACME threaded cap is included. Meets ARI 700 regulations, and is compliant for use in California.

    Expedited shipping not available for this product. Can only be shipped via UPS Ground or Freight.

    Key Features:

    • Part number: 6330
    • Unit UPC: 39101063300
    • Unit weight: 36.25lb
    • Content weight: 30lb.


    • Flash point: NAGas
    • Boiling point: -15.5°F
    • Specific gravity: 1.21
    • Propellant: not applicable
    • Clear, colorless liquid/vapor
    • Ether-like odor
    • Low flammability
    • Plastic safe


    • VOC%: not determined
    • VOC category: not applicable
    • Compliant for CA




    Learn More
  2. Johnsen's R134a Air Conditioning Refrigerant 12 Oz Cans - 12 PACK

    Johnsen's R134a Air Conditioning Refrigerant 12 Oz Cans - 12 PACK


    12 PACK of Cans

    Application Temperature Range
    R-134a performance suffers at lower evaporator temperatures. In general it is not applied at temperatures below -10F, and it is not necessarily the most economical overall choice in some other applications. Traditional R-12 type applications have adopted several products as alternatives, including R-134a, R-22, R-404A/R-507, and numerousretrofit blends.

    R-134a requires polyol ester (POE) lubricants, primarily for their ability to mix with HFC refrigerants. Traditional mineral oils and alkylbenzene do not mix with HFCs and will cause compressor failures. In addition, automotive air conditioning systems may also use polyalkaline glycol (PAG) lubricants (not typically seen in stationary equipment). Both POEs and PAGs will absorb moisture, and hold onto it, to a much greater extent than traditional lubricants. The moisture will promote reactions in the lubricant as well as the usual problems associated with water (corrosion, acid formation, etc.). The best way to dry a wet HFC system is to use a filter drier - run the system and change the drier - instead of relying on evacuation to clear the water.

    Retrofitting Considerations
    Equipment built for R-12 will be sized a bit too small compared to equipment built for R-134a. In order to do the same job an R-134a system will need a larger compressor and larger heat exchangers. As a result a system which is retrofit from R-12 to R-134a will have lower capacity (run longer) and will probably develop higher head pressures (not enough condenser area). The lubricant will also need to be flushed and replaced with POE (residual mineral oil content less than 5%).

    This product cannot go expedited shipping, must go ground.

    Learn More
  3. 24 LED Amber Light Bar with Clear Cover

    24 LED Amber Light Bar with Clear Cover

    The 24 LED Amber Light Bar is a great way to be noticed and stand out while on the road!
    Product Features:
    • Working Voltage: DC 12V
    • Current: 3 amps 
    • Light Source:LED
    • 7 Flash Patterns - Can Be Changed Manually
    • Lamp Color Available: Amber
    • Cover Color: Clear
    • On/Off switch
    • 9 1/2' Cable
    • 2 Magnet Standers
    • Headlight Material: PMMA


    • Length - 11 Inches
    • Width - 6.5 Inches
    • Height - 2.5 Inches
    Learn More
  4. 22-A Substitutes Refrigerant - Second generation replacement for R407c, R404a and MO99

    22-A Substitutes Refrigerant - Second generation replacement for R407c, R404a and MO99


    Why Switch from the Traditional R22 Refrigerants

    Frost 22a Refrigerant Replaces R22 Substitutes

    Frost 22a is sold as a second generation replacement for R407c, R404a and MO99.

    • Do it Yourself!
    • No license Required
    • Use up to 40% less
    • Lower operating costs
    • Less heaed pressure, extremely efficient
    • Non-ozone depleting product
    • Non-Toxic, Non-Carcinogen - No Long Term health Risks
    • Compatible with Mineral & Synthetic (Ester & Pag) Lubricants
    • Proven Results
    • Classified as Pharmaceutical Grade
    • Government phasing out traditional R22
    • Made in USA
    • Hydro Carbon Leak Detector is recommended for checking Leaks (Leak Detector Not Included)

    *This product is equaivalent to 30 lbs of traditional R-22. Because this is a lighter gas you will only need to use 1oz of 22A for every 2.5oz you had to use with traditional R-22.

    This product cannot go expedited shipping, must go UPS Ground or Freight.

    **This is a flammable substance.

    Guidelines for the Pressure of 22A

    Charge low side pressure to around 70 PSI. Your high side pressure should be around 230-250 PSI. Always fill from the low pressure side. It should be at about 40-44 degrees on the evaporator coil. Those are the ranges of a typical charge. 

    Learn More
  5. ADCO Products Bumper Pull SFS Aquashed Horse Trailer Cover 4600

    ADCO Products Bumper Pull SFS Aquashed Horse Trailer Cover 4600

    From: $115.97

    High performance polypropylene sides insure maximum breathability and virtually eliminate mold and mildew. Triple layer SFS AquaShed® top panel beads water on contact affording maximum resistance to high humidity and rainfall in addition to protection against UV rays. Includes storage bag for easy stowing of cover.

    Product Features:

    • Zipper entry doors on both the passenger and driver side
    • Breathable polypropylene side panels
    • Cinching system to remove slack
    • Reinforced corners to reduce wear
    • Highly water resistant top panel
    • Attached straps and buckles hold cover in place
    • Elasticized front and rear corners for a snug fit
    • Storage bag
    • Moderate sun exposure
    • High moisture
    • 2 years warranty
    Learn More
  6. TowTek 6" x 30' Recovery Strap 55,000 lb. Capacity RS630

    TowTek 6" x 30' Recovery Strap 55,000 lb. Capacity RS630


    Product Features

    • 6 inches wide x 30 feet long durable webbed strap
    • Features a sewn end loop with an overlay of high-tenacity nylon to ensure longer life in the pull area
    • Sewn in loop also makes it easier to attach the strap loop to the tow hooks on the vehicle
    • 5,000 pounds breaking strength
    • 27,500 pounds maximum vehicle weight
    Learn More
  7. Better Built 20" ATV Truck Box 67011386

    Better Built 20" ATV Truck Box 67011386


    The ATV box is a great source of water resistant storage to accommodate any ATV. The lockable paddle handle provides for greater security of your valuable articles. - Water resistant storage - Provides secure storage space - Constructed of aluminum - Will never rust


    Measures 7.75" x 20" x 12"

    Learn More
  8. Hi-Lift Jack Co. All-Cast 48 in. Jack - Red HL-485

    Hi-Lift Jack Co. All-Cast 48 in. Jack - Red HL-485


    Product Description

    Only Hi-Lift Jacks are made with a two-piece handle and socket design that is built for extended life. Cheaper imitations use a one-piece design that bends easily if lateral pressure is applied while lifting a load.

    Our jacks are designed to help you survive in the most demanding situations – whether you are in the Moab desert canyons, the Welsh Mountains, the Amazon jungle, or the farmlands of Indiana. With a full-range of specially designed accessories, the Hi-Lift jack is just about the most versatile piece of off-roading/farm/auto recovery equipment you can buy.

    When it's a heavy-duty situation, the tool had better be a Hi-Lift!

    Hi-Lift Jack Specifications

    • Approximate weight: 30lbs (14 kg)
    • 4,660 lbs (2113.74 kg) rated capacity
    • Tested capacity 7,000 lbs.
    • Climbing pins of specially processed steel with 125,000 PSI tensile strength and 100,000 PSI yield.
    • Steel bar is manufactured of specially rolled extra high carbon steel with 80,000 pound minimum tensile & carbon .69 to .82.
    • Steel handle of 14gauge high-yield structural tubing with minimum yield of 55,000 PSI. 1 5/16" diameter x 30" long.

    Hi-Lift Jack Features

    • Every Jack comes complete with an adjustable top clamp/clevis for use in clamping and winching.
    • Safety bolt is designed to shear at 7,000 lbs. (3175 kg)
    • For speedy disengaging, lifting unit automatically drops away when load is removed.
    • 4 1/2" (11cm) long lifting nose for positive contact with load.
    • Steel bar can be reversed for extra long life.
    • Low pickup of 4 1/2" (11cm).
    • 28 square inch base plate.
    Learn More
  9. TowTek Aluminum Cargo Carrier ACC500

    TowTek Aluminum Cargo Carrier ACC500


    This cargo carrier is the perfect addition to any road trip.  When the car starts to get full, strap the cooler, luggage, stroller, whatever you may have to this cargo carrier and make more space inside your vehicle.  This carrier attaches easily through a 2" receiver on your car and makes connecting and disconnecting a snap. 

    Product Features:

    • Ultra light aluminum
    • 500 lb. maximum capacity
    • Attaches easily to your vehicle

    Dimensions: 9.5" H x 49.5" W x 22.5" D

    Learn More
  10. Tire Forklift 6.00 X 9 Industrial

    Tire Forklift 6.00 X 9 Industrial

    [description] Learn More

Items 1-10 of 414

per page
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Grid List

Set Ascending Direction