The PB B'laster acts as a powerful, concentrated catalyst to release the surface tension of frozen parts. Then it converts into a nonevaporating lubricant to protect against further rust and corrosion. Penetrates fast into hard-to-reach cavities to free stubborn, rusted, or immobilized parts; nuts, bolts, screens, joints, pipe threads, and more. Contains no dangerous vinyl methylene chlorides, gasoline, kerosene, fuel, or cheap oils.Learn More
Purple Power® Industrial Strength Cleaner Degreaser.
This versatile cleaner and degreaser is effective on a wide variety of surfaces. The concentrated formula penetrates grease, oil and dirt on contact, then it creates a barrier between the stain and the surface. In just seconds you can wipe away even the toughest stains.Learn More
Smart Straw design allows for one-handed operation. Simply flip it up for a precision stream, and down for a regular spray action.
Known as "the can with a thousand uses," WD-40 protects metal from rust and corrosion, penetrates stuck parts, displaces moisture, and lubricates just about anything. WD-40 is also great when it comes to cleaning grease, grime, and other marks from most surfaces.
FIVE BASIC FUNCTIONS:
- CLEANS: It gets under dirt, grime and grease to clean. It also dissolves adhesives, allowing easy removal of labels, tape, stickers, and excess bonding material.
- DISPLACES MOISTURE: It quickly dries out electrical systems to eliminate moisture-induced short circuits.
- PENETRATES: Loosens rust-to-metal bonds and frees stuck, frozen or rusted metal parts.
- LUBRICATES: Lubricating ingredients are widely dispersed and hold firmly to all moving parts.
- PROTECTS: Protects metal surfaces with corrosion-resistant ingredients to shield against moisture and other corrosive elements.
Gumout Carb and Choke Cleaner quickly and easily cleans gum, varnish and dirt off the outside of the carburetor and the inside of the carburetor throat.
Helps overcome the following:
- Hard starting
- Rough idling
- High exhaust emissions
- Loss of pep
Directions for Use
- 1. KEEP AWAY FROM BATTERY TERMINALS AND ELECTRICAL CONNECTIONS. SPRAY WITH CAN IN UPRIGHT POSITION.
- 2. Insert plastic tube firmly into valve button.
- 3. WITH ENGINE OFF AND COOL: CARBURETOR: Remove the air cleaner and clean the outside of the carburetor and all of the linkage. Avoid spraying electrical connections. MANIFOLD HEAT CONTROL: Spray GUMOUT® on exposed ends of cool heat riser shaft. Allow to penetrate and clean. Move counterweight up and down until free.
- 4. WITH ENGINE RUNNING: CARBURETOR: Spray GUMOUT® to both ends of the choke valve shaft while working choke by hand. Spray down and around the carburetor throat to remove deposits from the throttle plate area. DO NOT SPRAY DOWN CARBURETOR THROAT WITH ENGINE OFF. DO NOT SPRAY BELOW THROTTLE PLATE. CHOKE: If choke sticks, remove choke cover and spray. PCV VALVE: Disconnect the crankcase side of the valve and spray GUMOUT® into the open end of the valve while working the plunger back and forth.
- NOT RECOMMENDED FOR FUEL INJECTED VEHICLES. USE GUMOUT® AIR INTAKE AND THROTTLE BODY CLEANER INSTEAD.
- WILL NOT HARM CATALYTIC CONVERTERS OR OXYGEN SENSORS. CONTAINS NO METHANOL OR METHYLENE CHLORIDE.
- If sprayed on painted surface, wipe off at once. Meets current VOC regulations.
- Treats as much as a 50 lb. bag of rock salt
- Spray on before a storm to prevent ice and snow build up
- After a storm, use as an instant ice melter
- Will not harm concrete, asphalt or plants
- Protects in temperatures to -27F
- Extra soft
- Picks up dust and grit from freshly polished surfaces
- 4 square yards