Evenly distributes seed, light weight fertilizer, granular and other materials.
- Sturdy zip top canvas bag
- Calibrated flow rate adjuster
- Adjustable shoulder strap
- Sturdy man made fibre strap
- Stainless steel rate gate
- Handy calibration chart
- 25lb. capacity (approximately)
- Easy on/off controls .
The Briggs & Stratton Fuel Pump is a replacement pump for the following Briggs part numbers: 691034, 808281, 692313, 491922, 808322, 557033, 808656 and 808492. The 808656 fits most 12Y000 and 185000 model Briggs & Stratton Engines.
- Fuel Replacement Pump
- Genuine Briggs & Stratton Part
- Original Equipment Manufacturer Part
- Fits most 12Y000 and 185000 Model Briggs Engines
The engine zone restart cable's dimensions are total Length: 53 5/8'' Housing Length: 46 1/2''. Both ends are a cast "Z" Bend. Handle end wraps around handle, with a peg that locates and locks it in place. Often these pegs wear down or break when the cable starts to bind in the housing, causing a no-start because the cable wont move far enough to pull the engine brake switch to "on" position. Safety Zone Start cable fits many models of AYP, Husqvarna, Craftsman Sears walk behind mowers.
- Total Length (in.): 53-5/8"
- Housing Length (in.): 46-1/2"
Extend the life of your tools by keeping them inside and off the ground. This hanging rack can be easily mounted on a wall in your shed, garage or basement to accommodate long-handled tools and organize smaller tools, such as screwdrivers, pliers and other hand tools.
- Two 25-1/2" channels
- Five separate large-tool holders that snap into the channel
- One small-tool holder that snaps into the channel
The AYP Mower Engine Control Cable, model # 176556, has a Z bend on each end and is a replacement piece that fits models: AYP PO500N21R, PR160N21CHC, PR4N22SHA, PR550N21RH3, WM500N21R, XT625N21RH3.
- Conduit Length (in.): 45-3/8"
- Cable Length (in.): 52-1/2"
The AYP 6-1/4" Mandrel Pulley is an Original Equipment Manufacturer replacement pulley for many brands such as: Husqvarna, Poulan, Poulan Pro, Roper, Craftsman and Weed Eater. The 195945 Pulley is 6-1/4 inch with a hole to fit on the splined shaft.
- Pre-drilled hole to fit a splined shaft
- Replacement piece for many brands
- Original Equipment Manufacturer part
- Diameter (in.): 6-1/4"